Print #6 – Ironman

After finally conquering the One Ring print, I decided I wanted to try and do a figure. So I pulled Ironman from Thingiverse. I added supports and hollowed him out, I put holes in the head and shoulders for drainage.

Print #6 - Ironman
Print #6 – Ironman. Not too bad. Some shoulder damage from not enough supports, but overall pretty neat.

I didn’t properly support the shoulders enough and lost a shoulder armor piece. When I get around to learning how to paint them, I can make this one battle worn! Another lesson learned from this print is not to use shallow supports for a flat base. Either print the base on the plate, or put the figure at an angle of 45 degrees or so. My base here started to delimatinate a bit.